Several of my major parts arrived and I began assembly. The adapter plaste and coupler were ordered from Electric Vehicles America. When ordering you must provide three critical measurements:

  1. The distance from the face of the transmission to the tip of the input shaft
  2. The distance from the face of the transmission to the beginning of the splines
  3. The distance from the face of the transmission to the end of the splines.

Using the measurements an adapting coupling will be designed and they will include instructions for removing your pilot bearing (if required). After collecting these measurements you will send them, along with your transmission clutch disk, to the EVA machinist. In a few weeks you will receive your adapter kit.

Once you have trimmed and cut your adapter plate and mounted it and the coupler to the motor it will resemble the images below.

« Component Selection
Batteries! »

This entry was posted on Monday, October 27th, 2008 at 7:06 pm and is filed under EVBIMMER. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.